Firmly fasten B screws with I washers to connect Soundbar to the Soundbar connectors. Position the Soundbar as close to display as possible.
Make sure that the screw inserts on the display and attachment rails are aligned. The bottom end of the display attachment rails should be flush with the bottom of your display. Place the display mount arms on top of the display attachment rails. Position the Soundbar display attachment rails on the back of the display mounting points. Place the Soundbar face down and position it as close to the display as possible. Use the A screws to attached the connector to the display attachment rails.Ĭarefully place the display face down on a soft flat surface. Various depths can be accomplished by using C or D screws accompanied by I washers and G nuts. The recessed Soundbar connector will align with displays from 1 7/32” (31.74mm) to 2 3/32” (53mm) deep displays. This is dependent on the display thickness and installation preference. If the spacers are not used the front surface of the display will be in line with the front radius of the Soundbar grille. When using the spacers carefully place the display on top of the spacers. The spacers allow the front surface of the display to be in line with the flat surface on the top edge of the Soundbar. Included with your Soundbar are two 8mm thick wood display spacers. Use the A screws to connect to the display attachment rails. The flat Soundbar connector will align with 2 5/8” (65mm) displays. The recessed Soundbar connector will align with displays from 1 7/32” – 2 3/32” (31.74mm – 53mm) deep. The flat Soundbar connector will align with 2 5/8” (65mm) deep displays. Soundbar Connectors for Wall Mount BracketsĬhoose and attach the correct Soundbar connector to the display attachment rails for your desired depth. Key hole wall mounting is an alternative option accomplished by using the key hole wall mounts combined with the wall mount template. Soundbars can additionally be cabinet or table top mounted using the rubber feet included in your box contents. The Recessed Soundbar Connector will align with displays from 1 7/32” – 2 3/32” (31.74mm – 53mm) deep. Mounting Option 2 – Recessed Soundbar Connector
The Flat Soundbar Connector will align with displays 2 5/8” (65mm) deep. Mounting Option 1 – Flat Soundbar Connector Soundbar SB46 M and SB46 L are designed to attach directly to most flat panel display wall mounts using VESA mounting points with the included attachment rails, connectors, and hardware. NOTE: CONSULT LOCAL BUILDING CODES BEFORE RUNNING SPEAKER AND ELECTRICAL WIRES THROUGH WALLS. Extra wire can then be pushed back into the wall. Whenever possible leave extra wire to make it easy to connect the wire to the Soundbar spring terminals prior to hanging the display. Run three sets of speaker wires: Left channel, Center channel, Right channel as well as the necessary video cable from the amplifier to the display location. If you are unsure about obstructions, drill a small hole near where the Soundbar wire terminals will be located and insert a coat hanger wire into the hole to feel around for possible obstructions. Perform an obstruction survey using a stud finder to be certain there are no studs, conduit, pipes, heating ducts, pocket doors or air returns in the wall cavity. NOTE: CAREFULLY FOLLOW INSTALLATION DIRECTIONS FOR THE THIRD PARTY DISPLAY WALL MOUNT.īefore any installation carefully plan where wiring will pass through walls.
0 kommentar(er)
